What does bathroom plumbing work cost in Gloucestershire?
Our guide range in Gloucestershire is £600–£4,100 including VAT.
Like-for-like
- New suite in the same positions
Partial re-route
- New hot and cold runs
New layout
- Pump or pressure upgrade
Guide prices for Gloucestershire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Gloucestershire?
Water across much of Gloucestershire is hard. Taps, plug wastes and toilet pans scale up quickly, so chrome copes better than matt black, and a removable aerator is worth having. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Gloucester bathroom layout is changing, the soil stack position is checked first, because it decides where the WC can go.
What the job includes
- Draining down and isolating supplies, with the rest of the house back on water as soon as possible
- A check of your hot water system, and the pressure and flow rate at the bathroom
- The WC connected to the soil stack, or a new branch where the WC is moving
- New hot and cold pipework in copper or plastic, properly clipped, and insulated where it runs through cold spaces
- Basin, bath and shower wastes sized and laid to a steady fall, with traps that hold their water seal
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
Decisions to make first
Concealed or exposed valves
Concealed shower valves look neater but need an access route for servicing. Exposed bar valves are easier to reach and replace.
Gravity or pumped waste
Gravity drainage is always the first choice. A shower waste pump or macerator solves a run that cannot fall, but adds noise, a power supply and servicing.
Pipe routes
Drilling through the middle of joists, rather than notching the tops, keeps the floor strong. Routes are planned with the joist direction in mind.
Copper or plastic
Copper is rigid and suits pipes on show or near the boiler. Plastic is quicker under floors and inside walls, and long runs need fewer joints.
Rules that apply in England
New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.
In England, the Water Supply (Water Fittings) Regulations 1999 apply. New drainage or a new connection to the soil stack can be building regulations work under Part H, and a macerator or pumped WC is acceptable only where there is also a WC on gravity drainage elsewhere in the home.