What does bathroom plumbing work cost in Herefordshire?
Our guide range in Herefordshire is £600–£3,900 including VAT.
Like-for-like
- New suite in the same positions
Partial re-route
- New hot and cold runs
New layout
- Pump or pressure upgrade
Guide prices for Herefordshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Herefordshire?
Water across much of Herefordshire is moderately hard. Taps and wastes will need an occasional descale, and chrome or brushed finishes are easier to keep clean than polished brass. Hardness varies street by street, so check the figure for your postcode with your water supplier. Plumbing surveys in Hereford include a look at the existing pipework for lead, corrosion or poor support before we quote.
What the job includes
- The WC connected to the soil stack, or a new branch where the WC is moving
- Shower pumps on gravity systems, and macerators or pumped wastes where gravity drainage cannot reach
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
- A pressure test of new pipework before walls are closed in and floors go down
- Draining down and isolating supplies, with the rest of the house back on water as soon as possible
- A check of your hot water system, and the pressure and flow rate at the bathroom
Decisions to make first
Pipe routes
Drilling through the middle of joists, rather than notching the tops, keeps the floor strong. Routes are planned with the joist direction in mind.
Concealed or exposed valves
Concealed shower valves look neater but need an access route for servicing. Exposed bar valves are easier to reach and replace.
Hard water
In hard water areas, a scale reducer or water softener protects valves, shower heads and glass. Keep an unsoftened tap in the kitchen for drinking.
Gravity or pumped waste
Gravity drainage is always the first choice. A shower waste pump or macerator solves a run that cannot fall, but adds noise, a power supply and servicing.
Rules that apply in England
New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.
In England, the Water Supply (Water Fittings) Regulations 1999 apply. New drainage or a new connection to the soil stack can be building regulations work under Part H, and a macerator or pumped WC is acceptable only where there is also a WC on gravity drainage elsewhere in the home.