Loft bathrooms in East Kilbride

Postcode districts: G74
Nearby: Cambuslang, Blantyre and Rutherglen
Guide price: £6,200–£12,500
Typical time on site: 6–12 working days
Water: Soft across most of Lanarkshire
Survey: Free, at your home

What does a loft bathroom cost in East Kilbride?

As a guide, budget £6,200 to £12,500 including VAT for a loft bathroom in East Kilbride; your written quote will pin it down. Prices in Scotland run at about 4% below the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.

Refit

£5,300–£8,200

Existing loft shower room

Typical

Signature

£7,700–£12,500

Fitted furniture to the eaves

New loft bathroom

£9,600–£17,250

Ventilation and electrics to regulations

Guide prices for East Kilbride including VAT. Your itemised written quote after the free survey is the price that counts.

Working in East Kilbride

We cover every part of East Kilbride, including G74, and nearby Cambuslang (3.2 miles) and Blantyre (3.9 miles).

East Kilbride has a wide mix of house ages, so the survey is where we spot old lead pipework, weak joists or a tight soil stack. If your East Kilbride home has a gravity-drained WC on another floor, a macerator in the loft may open up more layout options. If your East Kilbride loft conversion has a bedroom but no bathroom, the survey starts with where the soil stack runs and how much headroom you have.

Supplies across most of Lanarkshire are soft. If that holds for your street in East Kilbride, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier.

What the job includes

An extractor fan ducted through the roof or a gable wall, with the duct insulated through cold spaces
Electrics by a qualified electrician, tested and certified, then tiling, testing and handover
A shower pump on a gravity system, an electric shower, or advice on moving to mains pressure, depending on your system
A drainage route from the loft to the soil stack with enough fall, or a pumped waste or macerator where the rules allow it

Decisions to make first

Eaves storage

Low cupboards built into the slope behind the WC or basin take clutter out of the room and hide the pipework.

Where the shower goes

Under the ridge or in a dormer, where the full height is. A walk-in shower with a single panel is usually easier to fit to a roof line than a framed enclosure.

Rules that apply in Scotland

In Scotland, forming a new bathroom in the loft or altering the drainage may need a building warrant. The Technical Handbook uses 15 litres per second extract for a bathroom, and water fittings are covered by the Scottish Water Byelaws 2014.

More about loft bathrooms

Loft bathrooms in East Kilbride: questions

What is the price of a loft bathroom in East Kilbride?

A loft bathroom in East Kilbride usually costs £6,200–£12,500 including VAT. The final figure comes down to what you choose and what we find at the survey; your written quote lists every item so you can see where the money goes.

Do you cover G74 in East Kilbride?

Yes. We cover all of East Kilbride, including G74, and nearby Cambuslang, Blantyre and Rutherglen. Survey visits are free and arranged at a time that suits you.

Is the water hard in East Kilbride?

Will a loft bathroom in East Kilbride need a building warrant?

Usually not for a straight refit. Building warrants are issued by the local council's building standards service, and forming a new bathroom, changing drainage or structural work can need one. We tell you at the survey and handle the application if one is needed.

Do I need a pump for a loft shower?

You need a pump if your hot water comes from a cylinder fed by a cold tank, because the tank usually sits at or below the height of a loft shower and gives almost no pressure. A combi boiler or unvented cylinder supplies mains pressure, so no pump is needed, though the flow can drop when other taps run. Shower pumps must only be used on gravity systems, never connected to the mains.