- Postcode districts
- HU17
- Nearby
- Kingston upon Hull, Brough and Bridlington
- Guide price
- £400–£3,300
- Typical time on site
- half a day to 3 days
- Water
- Hard across most of the East Riding of Yorkshire
- Survey
- Free, at your home
What does a new shower cost in Beverley?
For Beverley, our guide range for a new shower is £400 to £3,300 including VAT. Prices in Yorkshire and the Humber run at about 7% below the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Test and handover
New shower over bath
- Thermostatic bar shower and riser
New shower with enclosure
- Pipework and waste
Guide prices for Beverley including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Beverley
We work right across Beverley — HU17 — and in neighbouring Kingston upon Hull and Brough.
In Beverley, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. If you want a shower in your Beverley home that works when the boiler is off, an electric shower is worth considering, as long as the consumer unit can take the circuit. We test pressure and flow at Beverley surveys before recommending a shower, so you know how it will perform before you buy.
Supplies across most of the East Riding of Yorkshire are hard. If your supply in Beverley is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
- Electrical connection by a qualified electrician, tested and certified
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
Decisions to make first
Head and handset
A handset on a riser rail is versatile and easy for rinsing; a fixed overhead head feels generous but needs strong flow behind it.
Power shower
A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.
