- Postcode districts
- OL10
- Nearby
- Middleton, Rochdale and Bury
- Guide price
- £400–£3,300
- Typical time on site
- half a day to 3 days
- Water
- Soft across most of Greater Manchester
- Survey
- Free, at your home
What does a new shower cost in Heywood?
Guide price in Heywood: £400–£3,300 including VAT, depending on the room and what you choose. We adjust the national guide for North West England, where prices are typically about 6% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Existing supply and position
New shower over bath
- Tiling the bath surround
New shower with enclosure
- Tray, enclosure and valve
Guide prices for Heywood including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Heywood
As well as Heywood itself (OL10), we survey in Middleton, Rochdale and Bury.
In Heywood, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. For Heywood homes with a cold tank in the loft, we check the system before fitting anything, because a pump is only allowed on a gravity supply. If your Heywood bath has no shower over it, a thermostatic bar shower, screen and tiling can usually be added in a day or two.
Most of Greater Manchester is supplied with soft water. If that holds for your street in Heywood, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Electrical connection by a qualified electrician, tested and certified
- A check of your hot-water system, water pressure and flow rate
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
Decisions to make first
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Electric shower
Heats cold mains water as it flows, so it works without stored hot water. Higher kW units give more flow; 8.5 to 10.5 kW models need a dedicated circuit, often 40 to 45 amps.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.
