- Postcode districts
- WF7, WF8, WF10
- Nearby
- Castleford, Kippax and South Elmsall
- Guide price
- £400–£3,300
- Typical time on site
- half a day to 3 days
- Water
- Soft across most of West Yorkshire
- Survey
- Free, at your home
What does a new shower cost in Pontefract?
For Pontefract, our guide range for a new shower is £400 to £3,300 including VAT. We adjust the national guide for Yorkshire and the Humber, where prices are typically about 7% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Like-for-like mixer or electric shower
New shower over bath
- Bath screen
New shower with enclosure
- Tiling to the enclosure
Guide prices for Pontefract including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Pontefract
We cover every part of Pontefract, including WF7, WF8 and WF10, and nearby Castleford (3.2 miles) and Kippax (5.8 miles).
Homes in and around Pontefract vary, so we look at the floor, the walls and the water system before we price anything. We test pressure and flow at Pontefract surveys before recommending a shower, so you know how it will perform before you buy. If you are replacing a failed electric shower in Pontefract, we check whether the existing cable and circuit suit the new unit.
Supplies across most of West Yorkshire are soft. If that holds for your street in Pontefract, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
- A bath screen, tray or enclosure where the shower is new
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- Supply and fitting of the shower valve or unit, riser rail, handset or fixed head
Decisions to make first
Thermostatic mixer
Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.
