- Postcode districts
- CW12
- Nearby
- Biddulph, Kidsgrove and Sandbach
- Guide price
- £650–£2,400
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Moderately hard across most of Cheshire
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Congleton?
In Congleton, bathroom underfloor heating typically costs £650–£2,400 including VAT, based on North West England prices. We adjust the national guide for North West England, where prices are typically about 6% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Insulation board
Electric, larger room
- Electrician sign-off
Wet system
- Pipes linked to the heating
Guide prices for Congleton including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Congleton
We work right across Congleton — CW12 — and in neighbouring Biddulph and Kidsgrove.
In Congleton, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. For Congleton homes having the bathroom floor replaced, underfloor heating adds one to two days to the fit. If your Congleton bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer.
Water across much of Cheshire is moderately hard. Mid-tone grout and matt tiles hide the odd water mark better than dark grout and high gloss. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Bringing the system up to temperature gradually once the adhesive and grout have cured
- A floor sensor set between the heating runs and wired back to the thermostat
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
Decisions to make first
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Floor finish
Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.
