- Postcode districts
- BT29, BT41
- Nearby
- Ballymena, Newtownabbey and Belfast
- Guide price
- £600–£2,200
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Soft across most of County Antrim
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Antrim?
As a guide, budget £600 to £2,200 including VAT for bathroom underfloor heating in Antrim; your written quote will pin it down. Prices in Northern Ireland run at about 12% below the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Insulation board
Electric, larger room
- Electrician sign-off
Wet system
- Pipes linked to the heating
Guide prices for Antrim including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Antrim
In Antrim we cover BT29 and BT41; we also cover Ballymena, 10.4 miles away, and Newtownabbey.
Antrim gets the same process as anywhere else: a free survey at your home and a written, itemised quote. If your Antrim bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer. We check door thresholds in Antrim homes at the survey, because underfloor heating and new tiles raise the floor slightly.
Most of County Antrim is supplied with soft water. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
- A floor sensor set between the heating runs and wired back to the thermostat
- Bringing the system up to temperature gradually once the adhesive and grout have cured
Decisions to make first
Floor finish
Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Rules that apply in Northern Ireland
Northern Ireland has no Part P, but the heating circuit should be designed, tested and certified to BS 7671, with RCD protection. Building control is not usually involved unless drainage or structural work is being done alongside it.

