- Postcode districts
- BT47, BT48
- Nearby
- Limavady, Coleraine and Magherafelt
- Guide price
- £600–£2,200
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Soft across most of County Londonderry
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Derry?
In Derry, bathroom underfloor heating typically costs £600–£2,200 including VAT, based on Northern Ireland prices. Prices in Northern Ireland run at about 12% below the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Thermostat and RCD-protected supply
Electric, larger room
- Whole floor coverage
Wet system
- Manifold or single-zone kit
Guide prices for Derry including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Derry
As well as Derry itself (BT47 and BT48), we survey in Limavady, Coleraine and Magherafelt.
Derry is a big place with every kind of home, from terraces to flats to new builds, so we never price from a photo alone. We check door thresholds in Derry homes at the survey, because underfloor heating and new tiles raise the floor slightly. Whether your Derry bathroom is a small en-suite or a large main bathroom, the mat is sized to the open floor, not the whole room.
Water across much of County Londonderry is soft. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
- The electric mat or cable laid to the open floor, kept clear of where the WC, bath and fixed furniture will sit
- Bringing the system up to temperature gradually once the adhesive and grout have cured
- A floor sensor set between the heating runs and wired back to the thermostat
Decisions to make first
Thermostat
A simple dial thermostat, a programmable one with set times, or a smart thermostat you can control from your phone.
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Rules that apply in Northern Ireland
Northern Ireland has no Part P, but the heating circuit should be designed, tested and certified to BS 7671, with RCD protection. Building control is not usually involved unless drainage or structural work is being done alongside it.

