- Postcode districts
- OL6, SK15, SK16
- Nearby
- Dukinfield, Ashton-under-Lyne and Hyde
- Guide price
- £650–£2,400
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Soft across most of Greater Manchester
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Stalybridge?
Our guide price for bathroom underfloor heating in Stalybridge is £650–£2,400 including VAT. We adjust the national guide for North West England, where prices are typically about 6% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Thermostat and RCD-protected supply
Electric, larger room
- Whole floor coverage
Wet system
- Manifold or single-zone kit
Guide prices for Stalybridge including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Stalybridge
As well as Stalybridge itself (OL6, SK15 and SK16), we survey in Dukinfield, Ashton-under-Lyne and Hyde.
Homes in and around Stalybridge vary, so we look at the floor, the walls and the water system before we price anything. We check door thresholds in Stalybridge homes at the survey, because underfloor heating and new tiles raise the floor slightly. Whether your Stalybridge bathroom is a small en-suite or a large main bathroom, the mat is sized to the open floor, not the whole room.
Most of Greater Manchester is supplied with soft water. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- A floor sensor set between the heating runs and wired back to the thermostat
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- A check of the floor construction, the room's heat loss and where the thermostat and supply will go
Decisions to make first
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Floor finish
Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

