- Postcode districts
- WA3, WA12, WN4
- Nearby
- Newton-le-Willows, Ashton in Makerfield and Leigh
- Guide price
- £650–£2,400
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Soft across most of Merseyside
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Golborne?
In Golborne, bathroom underfloor heating typically costs £650–£2,400 including VAT, based on North West England prices. We adjust the national guide for North West England, where prices are typically about 6% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for Golborne including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Golborne
We cover every part of Golborne, including WA3, WA12 and WN4, and nearby Newton-le-Willows (1.9 miles) and Ashton in Makerfield (2.2 miles).
Golborne gets the same process as anywhere else: a free survey at your home and a written, itemised quote. Where a Golborne home already has a heat pump, or the heating is being altered, a wet underfloor system is worth comparing with electric. If your Golborne home has a suspended timber floor, insulation boards under the mat stop heat disappearing into the void below.
Water across much of Merseyside is soft. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- A floor sensor set between the heating runs and wired back to the thermostat
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
Decisions to make first
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Floor heating and towel rail
Underfloor heating warms the room; a towel rail dries towels. Many bathrooms have both, and a dual-fuel rail keeps working in summer when the boiler is off.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

