- Postcode districts
- IV30
- Nearby
- Lossiemouth, Forres and Buckie
- Guide price
- £650–£2,400
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Soft across most of Moray
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Elgin?
For Elgin, our guide range for bathroom underfloor heating is £650 to £2,400 including VAT. We adjust the national guide for Scotland, where prices are typically about 4% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Thermostat and RCD-protected supply
Electric, larger room
- Whole floor coverage
Wet system
- Manifold or single-zone kit
Guide prices for Elgin including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Elgin
We cover every part of Elgin, including IV30, and nearby Lossiemouth (5.1 miles) and Forres (11.5 miles).
Homes in and around Elgin vary, so we look at the floor, the walls and the water system before we price anything. We check door thresholds in Elgin homes at the survey, because underfloor heating and new tiles raise the floor slightly. If your Elgin bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer.
Supplies across most of Moray are soft. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- The electric mat or cable laid to the open floor, kept clear of where the WC, bath and fixed furniture will sit
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- A floor sensor set between the heating runs and wired back to the thermostat
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
Decisions to make first
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Floor finish
Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.
Rules that apply in Scotland
Scotland has no Part P. Underfloor heating added during a straight bathroom refit rarely needs a building warrant on its own, but it must be installed, tested and certified to BS 7671 with RCD protection.

