What does bathroom underfloor heating cost in Staffordshire?
Our guide range in Staffordshire is £700–£2,400 including VAT.
Electric mat
- Thermostat and RCD-protected supply
Electric, larger room
- Whole floor coverage
Wet system
- Manifold or single-zone kit
Guide prices for Staffordshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Staffordshire?
- Stoke-on-Trent
- Newcastle under Lyme
- Burton upon Trent
- Cannock
- Tamworth
- Stafford
- Lichfield
- Kidsgrove
- Burntwood
- Longton
- Rugeley
- Leek
- Great Wyrley
- Biddulph
Supplies across most of Staffordshire are moderately hard. Mid-tone grout and matt tiles hide the odd water mark better than dark grout and high gloss. Hardness varies street by street, so check the figure for your postcode with your water supplier. Whether your Stoke-on-Trent bathroom is a small en-suite or a large main bathroom, the mat is sized to the open floor, not the whole room.
What the job includes
- Bringing the system up to temperature gradually once the adhesive and grout have cured
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- A floor sensor set between the heating runs and wired back to the thermostat
- Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- A check of the floor construction, the room's heat loss and where the thermostat and supply will go
Decisions to make first
Thermostat
A simple dial thermostat, a programmable one with set times, or a smart thermostat you can control from your phone.
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Floor heating and towel rail
Underfloor heating warms the room; a towel rail dries towels. Many bathrooms have both, and a dual-fuel rail keeps working in summer when the boiler is off.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Rules that apply in England
Electric underfloor heating in a bathroom must be on a circuit with 30 mA RCD protection under BS 7671, and the thermostat is positioned to suit the bathroom zones. There is no separate approval for the heating itself, but it should have its own thermostat and timer so it only runs when needed, and the electrical work must meet BS 7671 — in England and Wales it is notifiable as bathroom electrical work. Any work on a gas boiler for a wet system must be done by a Gas Safe registered engineer.
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.