- Postcode districts
- CH64, CH65, CH66
- Nearby
- Garston, Speke and Hunts Cross
- Guide price
- £550–£3,800
- Typical time on site
- 1–5 working days
- Water
- Moderately hard across most of Cheshire
- Survey
- Free, at your home
What does bathroom plumbing work cost in Ellesmere Port?
Our guide price for bathroom plumbing work in Ellesmere Port is £550–£3,800 including VAT. Prices in North West England run at about 6% below the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Like-for-like
- Isolation valves, new tails
Partial re-route
- Waste re-routed
New layout
- WC moved on the soil stack
Guide prices for Ellesmere Port including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Ellesmere Port
We cover every part of Ellesmere Port, including CH64, CH65 and CH66, and nearby Garston (3.8 miles) and Speke (5 miles).
In Ellesmere Port, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. If your Ellesmere Port bathroom layout is changing, the soil stack position is checked first, because it decides where the WC can go. For Ellesmere Port homes on a combi boiler, we measure the flow rate at the bathroom before you choose a shower valve.
Most of Cheshire has moderately hard water. Taps and wastes will need an occasional descale, and chrome or brushed finishes are easier to keep clean than polished brass. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Basin, bath and shower wastes sized and laid to a steady fall, with traps that hold their water seal
- A pressure test of new pipework before walls are closed in and floors go down
- A check of your hot water system, and the pressure and flow rate at the bathroom
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
Decisions to make first
Gravity or pumped waste
Gravity drainage is always the first choice. A shower waste pump or macerator solves a run that cannot fall, but adds noise, a power supply and servicing.
Copper or plastic
Copper is rigid and suits pipes on show or near the boiler. Plastic is quicker under floors and inside walls, and long runs need fewer joints.
Rules that apply in England
In England, the Water Supply (Water Fittings) Regulations 1999 apply. New drainage or a new connection to the soil stack can be building regulations work under Part H, and a macerator or pumped WC is acceptable only where there is also a WC on gravity drainage elsewhere in the home.
