- Postcode districts
- WF13, WF15, WF16
- Nearby
- Liversedge, Batley and Cleckheaton
- Guide price
- £230–£550
- Typical time on site
- half a day
- Water
- Soft across most of West Yorkshire
- Survey
- Free, at your home
What does a bathroom extractor fan cost in Heckmondwike?
Our guide price for a bathroom extractor fan in Heckmondwike is £230–£550 including VAT. Prices in Yorkshire and the Humber run at about 7% below the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Extractor fan
- Wired to regulations
Inline fan
- Quiet fan in the loft void
Continuous extract
- Boost on humidity
Guide prices for Heckmondwike including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Heckmondwike
We work right across Heckmondwike — WF13, WF15 and WF16 — and in neighbouring Liversedge and Batley.
Heckmondwike gets the same process as anywhere else: a free survey at your home and a written, itemised quote. If your Heckmondwike bathroom has black mould on the ceiling or silicone, the fan and its duct are the first things we check. In Heckmondwike flats, a new vent through an outside wall may need freeholder consent, so we raise it at the survey.
Water across much of West Yorkshire is soft. Even so, condensation is the bigger problem in any bathroom, and a properly sized extractor is what deals with it. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Run-on timer, humidistat or light-linked switching set up to suit how the room is used
- Core-drilling through the wall, or ducting through the loft to a roof or soffit vent
- Wiring by a qualified electrician, with an isolator outside the room and RCD protection
- Rigid or semi-rigid ducting kept short and straight, and insulated where it crosses a cold loft
Decisions to make first
Intermittent or continuous
An intermittent fan runs during and after use. A continuous fan runs quietly all the time at a low rate and boosts when humidity rises.
Replacement air
A fan needs air to replace what it removes, so leave a gap of around 10 mm under the door or fit a door grille. A sealed room starves the fan.
Rules that apply in England
In England, Approved Document F sets bathroom extract at 15 l/s for an intermittent fan or 8 l/s for continuous extract. Wiring a new fan alters a circuit in a room with a bath or shower, so it is notifiable under Part P.
