- Postcode districts
- SG5, SG6, SG15
- Nearby
- Hitchin, Stevenage and Biggleswade
- Guide price
- £500–£3,700
- Typical time on site
- half a day to 3 days
- Water
- Very hard across most of Hertfordshire
- Survey
- Free, at your home
What does a new shower cost in Letchworth Garden City?
Guide price in Letchworth Garden City: £500–£3,700 including VAT, depending on the room and what you choose. We adjust the national guide for East of England, where prices are typically about 6% above the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Like-for-like mixer or electric shower
New shower over bath
- Bath screen
New shower with enclosure
- Tiling to the enclosure
Guide prices for Letchworth Garden City including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Letchworth Garden City
In Letchworth Garden City we cover SG5, SG6 and SG15; we also cover Hitchin, 3.2 miles away, and Stevenage.
In Letchworth Garden City, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. For Letchworth Garden City homes with a cold tank in the loft, we check the system before fitting anything, because a pump is only allowed on a gravity supply. If you want a shower in your Letchworth Garden City home that works when the boiler is off, an electric shower is worth considering, as long as the consumer unit can take the circuit.
Water across much of Hertfordshire is very hard. If your supply in Letchworth Garden City is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- A check of your hot-water system, water pressure and flow rate
- Electrical connection by a qualified electrician, tested and certified
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
Decisions to make first
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Electric shower
Heats cold mains water as it flows, so it works without stored hot water. Higher kW units give more flow; 8.5 to 10.5 kW models need a dedicated circuit, often 40 to 45 amps.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.
