- Postcode districts
- CT5
- Nearby
- Herne Bay, Canterbury and Faversham
- Guide price
- £500–£3,900
- Typical time on site
- half a day to 3 days
- Water
- Very hard across most of Kent
- Survey
- Free, at your home
What does a new shower cost in Whitstable?
Our guide price for a new shower in Whitstable is £500–£3,900 including VAT. Labour costs in South East England put local prices at about 12% above the UK guide figure. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Test and handover
New shower over bath
- Thermostatic bar shower and riser
New shower with enclosure
- Pipework and waste
Guide prices for Whitstable including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Whitstable
We work right across Whitstable — CT5 — and in neighbouring Herne Bay and Canterbury.
In Whitstable, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. We test pressure and flow at Whitstable surveys before recommending a shower, so you know how it will perform before you buy. For Whitstable homes with a cold tank in the loft, we check the system before fitting anything, because a pump is only allowed on a gravity supply.
Water across much of Kent is very hard. If your supply in Whitstable is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
- A check of your hot-water system, water pressure and flow rate
Decisions to make first
Electric shower
Heats cold mains water as it flows, so it works without stored hot water. Higher kW units give more flow; 8.5 to 10.5 kW models need a dedicated circuit, often 40 to 45 amps.
Thermostatic mixer
Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.
