What does a new shower cost in West Sussex?
Our guide range in West Sussex is £500–£3,900 including VAT. Prices in West Sussex run at about 12% above the UK guide, based on South East England labour rates.
Shower swap
- Like-for-like mixer or electric shower
New shower over bath
- Bath screen
New shower with enclosure
- Tiling to the enclosure
Guide prices for West Sussex including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in West Sussex?
- Crawley
- Worthing
- Bognor Regis
- Littlehampton
- Horsham
- Haywards Heath
- Chichester
- Burgess Hill
- East Grinstead
- Shoreham-by-Sea
- Emsworth
- Lancing
Water across much of West Sussex is hard. If your supply in Crawley is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier. We test pressure and flow at Crawley surveys before recommending a shower, so you know how it will perform before you buy.
What the job includes
- Supply and fitting of the shower valve or unit, riser rail, handset or fixed head
- A check of your hot-water system, water pressure and flow rate
- Electrical connection by a qualified electrician, tested and certified
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
Decisions to make first
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Head and handset
A handset on a riser rail is versatile and easy for rinsing; a fixed overhead head feels generous but needs strong flow behind it.
Power shower
A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.
Thermostatic mixer
Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.
Rules that apply in England
The water fittings regulations in each nation do not allow a pump to be connected directly to the mains supply; shower pumps are for gravity systems with a cold tank only. The shower must also be protected against water flowing back into the supply. Electrics must meet BS 7671, with 30 mA RCD protection and at least IPX4 fittings in zone 1, or IPX5 where water jets are used.
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.