What does bathroom underfloor heating cost in County Fermanagh?
Our guide range in County Fermanagh is £600–£2,200 including VAT. Prices in County Fermanagh run at about 12% below the UK guide, based on Northern Ireland labour rates.
Electric mat
- Thermostat and RCD-protected supply
Electric, larger room
- Whole floor coverage
Wet system
- Manifold or single-zone kit
Guide prices for County Fermanagh including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in County Fermanagh?
Water across much of County Fermanagh is soft. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Enniskillen home has a suspended timber floor, insulation boards under the mat stop heat disappearing into the void below.
What the job includes
- A floor sensor set between the heating runs and wired back to the thermostat
- Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
- Bringing the system up to temperature gradually once the adhesive and grout have cured
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
Decisions to make first
Floor finish
Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.
Insulation board thickness
Thicker boards warm up faster and lose less heat downwards, but raise the floor; the right choice depends on the door threshold and the next room.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Rules that apply in Northern Ireland
Electric underfloor heating in a bathroom must be on a circuit with 30 mA RCD protection under BS 7671, and the thermostat is positioned to suit the bathroom zones. There is no separate approval for the heating itself, but it should have its own thermostat and timer so it only runs when needed, and the electrical work must meet BS 7671 — in England and Wales it is notifiable as bathroom electrical work. Any work on a gas boiler for a wet system must be done by a Gas Safe registered engineer.
Northern Ireland has no Part P, but the heating circuit should be designed, tested and certified to BS 7671, with RCD protection. Building control is not usually involved unless drainage or structural work is being done alongside it.