Underfloor heating in Ilkeston

Postcode districts: DE7, NG10
Nearby: Eastwood, Heanor and Long Eaton
Guide price: £650–£2,400
Typical time on site: 1–2 working days (added to a fit)
Water: Moderately hard across most of Derbyshire
Survey: Free, at your home

What does bathroom underfloor heating cost in Ilkeston?

Our guide price for bathroom underfloor heating in Ilkeston is £650–£2,400 including VAT. We adjust the national guide for East Midlands, where prices are typically about 4% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.

Typical

Electric mat

£650–£1,450

Thermostat and RCD-protected supply

Electric, larger room

£1,150–£2,100

Whole floor coverage

Wet system

£1,450–£2,900

Manifold or single-zone kit

Guide prices for Ilkeston including VAT. Your itemised written quote after the free survey is the price that counts.

Working in Ilkeston

In Ilkeston we cover DE7 and NG10; we also cover Eastwood, 2.1 miles away, and Heanor.

Homes in and around Ilkeston vary, so we look at the floor, the walls and the water system before we price anything. If your Ilkeston home has a suspended timber floor, insulation boards under the mat stop heat disappearing into the void below. For Ilkeston homes having the bathroom floor replaced, underfloor heating adds one to two days to the fit.

Supplies across most of Derbyshire are moderately hard. Mid-tone grout and matt tiles hide the odd water mark better than dark grout and high gloss. Hardness varies street by street, so check the figure for your postcode with your water supplier.

What the job includes

Bringing the system up to temperature gradually once the adhesive and grout have cured
For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
A floor sensor set between the heating runs and wired back to the thermostat

Decisions to make first

Mat or loose cable

Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.

Thermostat

A simple dial thermostat, a programmable one with set times, or a smart thermostat you can control from your phone.

Rules that apply in England

In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

More about underfloor heating

Underfloor heating in Ilkeston: questions

What is the price of bathroom underfloor heating in Ilkeston?

Bathroom underfloor heating in Ilkeston usually costs £650–£2,400 including VAT. Room size, layout changes and your choice of products move the figure within that range. The free survey gives you an itemised quote, fixed in writing once the details are agreed.

Is the home survey in Ilkeston really free?

Yes. We visit, measure the room, check the pipework, drainage and electrics, and talk through what you want. You then get a written, itemised quote with no obligation to go ahead.

Do you cover DE7 and NG10 in Ilkeston?

Yes. We cover all of Ilkeston, including DE7 and NG10, and nearby Eastwood, Heanor and Long Eaton. Survey visits are free and arranged at a time that suits you.

Is the water hard in Ilkeston?

Is underfloor heating enough to heat a bathroom on its own?

In a well-insulated bathroom with most of the floor open, it often is. In a small room, the bath, WC and furniture cover much of the floor, so the heated area may be too small to be the only heat source. A heated towel rail alongside is the usual answer.