- Postcode districts
- HU14, HU15
- Nearby
- Kingston upon Hull, Beverley and Scunthorpe
- Guide price
- £650–£2,300
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Hard across most of the East Riding of Yorkshire
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Brough?
Guide price in Brough: £650–£2,300 including VAT, depending on the room and what you choose. We adjust the national guide for Yorkshire and the Humber, where prices are typically about 7% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Insulation board
Electric, larger room
- Electrician sign-off
Wet system
- Pipes linked to the heating
Guide prices for Brough including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Brough
As well as Brough itself (HU14 and HU15), we survey in Kingston upon Hull, Beverley and Scunthorpe.
Brough gets the same process as anywhere else: a free survey at your home and a written, itemised quote. For Brough homes having the bathroom floor replaced, underfloor heating adds one to two days to the fit. If your Brough bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer.
Water across much of the East Riding of Yorkshire is hard. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Bringing the system up to temperature gradually once the adhesive and grout have cured
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
Decisions to make first
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Insulation board thickness
Thicker boards warm up faster and lose less heat downwards, but raise the floor; the right choice depends on the door threshold and the next room.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.
