What does bathroom underfloor heating cost in the East Riding of Yorkshire?
Our guide range in the East Riding of Yorkshire is £650–£2,300 including VAT. Prices in the East Riding of Yorkshire run at about 7% below the UK guide, based on Yorkshire and the Humber labour rates.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for East Riding of Yorkshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in the East Riding of Yorkshire?
Most of the East Riding of Yorkshire has hard water. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. Where a Kingston upon Hull home already has a heat pump, or the heating is being altered, a wet underfloor system is worth comparing with electric.
What the job includes
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- A check of the floor construction, the room's heat loss and where the thermostat and supply will go
- Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
- A floor sensor set between the heating runs and wired back to the thermostat
- The electric mat or cable laid to the open floor, kept clear of where the WC, bath and fixed furniture will sit
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
Decisions to make first
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Thermostat
A simple dial thermostat, a programmable one with set times, or a smart thermostat you can control from your phone.
Insulation board thickness
Thicker boards warm up faster and lose less heat downwards, but raise the floor; the right choice depends on the door threshold and the next room.
Floor finish
Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.
Rules that apply in England
Electric underfloor heating in a bathroom must be on a circuit with 30 mA RCD protection under BS 7671, and the thermostat is positioned to suit the bathroom zones. There is no separate approval for the heating itself, but it should have its own thermostat and timer so it only runs when needed, and the electrical work must meet BS 7671 — in England and Wales it is notifiable as bathroom electrical work. Any work on a gas boiler for a wet system must be done by a Gas Safe registered engineer.
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.