Underfloor heating in West Yorkshire

What does bathroom underfloor heating cost in West Yorkshire?

Our guide range in West Yorkshire is £650–£2,300 including VAT. Prices in West Yorkshire run at about 7% below the UK guide, based on Yorkshire and the Humber labour rates.

Guide prices for West Yorkshire including VAT. Your itemised written quote after the free survey is the price that counts.

Which towns do we cover in West Yorkshire?

• Leeds
• Bradford
• Huddersfield
• Wakefield
• Halifax
• Dewsbury
• Morley
• Keighley
• Castleford
• Pontefract
• Batley
• Yeadon
• Brighouse
• Shipley
• Cleckheaton
• Pudsey
• Lofthouse
• Ossett
• Guiseley
• Liversedge
• Horsforth
• South Elmsall
• Mirfield
• Heckmondwike
• Bingley
• Kippax
• Baildon
• Elland

Water across much of West Yorkshire is soft. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier. We check door thresholds in Leeds homes at the survey, because underfloor heating and new tiles raise the floor slightly.

What the job includes

• Bringing the system up to temperature gradually once the adhesive and grout have cured
• A check of the floor construction, the room's heat loss and where the thermostat and supply will go
• The electric mat or cable laid to the open floor, kept clear of where the WC, bath and fixed furniture will sit
• Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
• For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
• A floor sensor set between the heating runs and wired back to the thermostat

Decisions to make first

Floor heating and towel rail

Underfloor heating warms the room; a towel rail dries towels. Many bathrooms have both, and a dual-fuel rail keeps working in summer when the boiler is off.

Insulation board thickness

Thicker boards warm up faster and lose less heat downwards, but raise the floor; the right choice depends on the door threshold and the next room.

Floor finish

Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.

Mat or loose cable

Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.

Rules that apply in England

Electric underfloor heating in a bathroom must be on a circuit with 30 mA RCD protection under BS 7671, and the thermostat is positioned to suit the bathroom zones. There is no separate approval for the heating itself, but it should have its own thermostat and timer so it only runs when needed, and the electrical work must meet BS 7671 — in England and Wales it is notifiable as bathroom electrical work. Any work on a gas boiler for a wet system must be done by a Gas Safe registered engineer.

In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.