- Postcode districts
- EN11
- Nearby
- Ware, Hertford and Cheshunt
- Guide price
- £750–£2,600
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Very hard across most of Hertfordshire
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Hoddesdon?
As a guide, budget £750 to £2,600 including VAT for bathroom underfloor heating in Hoddesdon; your written quote will pin it down. Prices in East of England run at about 6% above the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for Hoddesdon including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Hoddesdon
In Hoddesdon we cover EN11; we also cover Ware, 3.5 miles away, and Hertford.
In Hoddesdon, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. If your Hoddesdon home has a suspended timber floor, insulation boards under the mat stop heat disappearing into the void below. We check door thresholds in Hoddesdon homes at the survey, because underfloor heating and new tiles raise the floor slightly.
Most of Hertfordshire has very hard water. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- The electric mat or cable laid to the open floor, kept clear of where the WC, bath and fixed furniture will sit
- Bringing the system up to temperature gradually once the adhesive and grout have cured
Decisions to make first
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

