- Postcode districts
- EN7, EN8, EN9
- Nearby
- Waltham Abbey, Enfield and Hoddesdon
- Guide price
- £750–£2,600
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Very hard across most of Hertfordshire
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Cheshunt?
As a guide, budget £750 to £2,600 including VAT for bathroom underfloor heating in Cheshunt; your written quote will pin it down. We adjust the national guide for East of England, where prices are typically about 6% above the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for Cheshunt including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Cheshunt
In Cheshunt we cover EN7, EN8 and EN9; we also cover Waltham Abbey, 1.4 miles away, and Enfield.
In Cheshunt, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. If your Cheshunt home has a suspended timber floor, insulation boards under the mat stop heat disappearing into the void below. Where a Cheshunt home already has a heat pump, or the heating is being altered, a wet underfloor system is worth comparing with electric.
Water across much of Hertfordshire is very hard. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- Bringing the system up to temperature gradually once the adhesive and grout have cured
- A check of the floor construction, the room's heat loss and where the thermostat and supply will go
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
Decisions to make first
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Insulation board thickness
Thicker boards warm up faster and lose less heat downwards, but raise the floor; the right choice depends on the door threshold and the next room.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

