- Postcode districts
- LE9, LE10
- Nearby
- Earl Shilton, Nuneaton and Bedworth
- Guide price
- £650–£2,400
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Hard across most of Leicestershire
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Hinckley?
For Hinckley, our guide range for bathroom underfloor heating is £650 to £2,400 including VAT. Labour costs in East Midlands put local prices at about 4% below the UK guide figure. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for Hinckley including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Hinckley
We work right across Hinckley — LE9 and LE10 — and in neighbouring Earl Shilton and Nuneaton.
Homes in and around Hinckley vary, so we look at the floor, the walls and the water system before we price anything. Where a Hinckley home already has a heat pump, or the heating is being altered, a wet underfloor system is worth comparing with electric. If your Hinckley bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer.
Most of Leicestershire has hard water. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- A floor sensor set between the heating runs and wired back to the thermostat
- Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
Decisions to make first
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

