- Postcode districts
- TS6, TS10
- Nearby
- Guisborough, Middlesbrough and Hartlepool
- Guide price
- £650–£2,300
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Moderately hard across most of North Yorkshire
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Redcar?
In Redcar, bathroom underfloor heating typically costs £650–£2,300 including VAT, based on Yorkshire and the Humber prices. We adjust the national guide for Yorkshire and the Humber, where prices are typically about 7% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for Redcar including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Redcar
We work right across Redcar — TS6 and TS10 — and in neighbouring Guisborough and Middlesbrough.
Homes in and around Redcar vary, so we look at the floor, the walls and the water system before we price anything. Where a Redcar home already has a heat pump, or the heating is being altered, a wet underfloor system is worth comparing with electric. For Redcar homes having the bathroom floor replaced, underfloor heating adds one to two days to the fit.
Water across much of North Yorkshire is moderately hard. Mid-tone grout and matt tiles hide the odd water mark better than dark grout and high gloss. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- A floor sensor set between the heating runs and wired back to the thermostat
Decisions to make first
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Floor finish
Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.
