- Postcode districts
- RH1, RH2
- Nearby
- Reigate, Horley and Caterham
- Guide price
- £800–£2,800
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Hard across most of Surrey
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Redhill?
For Redhill, our guide range for bathroom underfloor heating is £800 to £2,800 including VAT. Labour costs in South East England put local prices at about 12% above the UK guide figure. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for Redhill including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Redhill
We work right across Redhill — RH1 and RH2 — and in neighbouring Reigate and Horley.
Homes in and around Redhill vary, so we look at the floor, the walls and the water system before we price anything. We check door thresholds in Redhill homes at the survey, because underfloor heating and new tiles raise the floor slightly. If your Redhill bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer.
Most of Surrey has hard water. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
- A floor sensor set between the heating runs and wired back to the thermostat
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- Bringing the system up to temperature gradually once the adhesive and grout have cured
Decisions to make first
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

