What does bathroom plumbing work cost in Argyll and Bute?
Our guide range in Argyll and Bute is £600–£3,800 including VAT. Prices in Argyll and Bute run at about 4% below the UK guide, based on Scotland labour rates. Travel and delivery to islands and remote areas are priced on your quote.
Like-for-like
- New suite in the same positions
Partial re-route
- New hot and cold runs
New layout
- Pump or pressure upgrade
Guide prices for Argyll & Bute including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Argyll and Bute?
Most of Argyll and Bute is supplied with soft water. In soft water, taps, wastes and toilet pans scale up slowly, so brushed and matt finishes are a safe choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Helensburgh water is hard, a scale reducer or softener on the bathroom supplies can protect valves and shower heads.
What the job includes
- Shower pumps on gravity systems, and macerators or pumped wastes where gravity drainage cannot reach
- A check of your hot water system, and the pressure and flow rate at the bathroom
- The WC connected to the soil stack, or a new branch where the WC is moving
- A pressure test of new pipework before walls are closed in and floors go down
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
- Draining down and isolating supplies, with the rest of the house back on water as soon as possible
Decisions to make first
Copper or plastic
Copper is rigid and suits pipes on show or near the boiler. Plastic is quicker under floors and inside walls, and long runs need fewer joints.
Concealed or exposed valves
Concealed shower valves look neater but need an access route for servicing. Exposed bar valves are easier to reach and replace.
Hard water
In hard water areas, a scale reducer or water softener protects valves, shower heads and glass. Keep an unsoftened tap in the kitchen for drinking.
Gravity or pumped waste
Gravity drainage is always the first choice. A shower waste pump or macerator solves a run that cannot fall, but adds noise, a power supply and servicing.
Rules that apply in Scotland
New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.
In Scotland, the Scottish Water Byelaws 2014 cover new water fittings, with the same 6-litre flush limit and backflow rules. Altering drainage may need a building warrant, so check before moving a WC or adding a new connection to the stack.