What does bathroom plumbing work cost in Fife?
Our guide range in Fife is £600–£3,800 including VAT. Prices in Fife run at about 4% below the UK guide, based on Scotland labour rates.
Like-for-like
- Isolation valves, new tails
Partial re-route
- Waste re-routed
New layout
- WC moved on the soil stack
Guide prices for Fife including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Fife?
Most of Fife is supplied with soft water. In soft water, taps, wastes and toilet pans scale up slowly, so brushed and matt finishes are a safe choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Dunfermline water is hard, a scale reducer or softener on the bathroom supplies can protect valves and shower heads.
What the job includes
- Shower pumps on gravity systems, and macerators or pumped wastes where gravity drainage cannot reach
- A pressure test of new pipework before walls are closed in and floors go down
- Basin, bath and shower wastes sized and laid to a steady fall, with traps that hold their water seal
- New hot and cold pipework in copper or plastic, properly clipped, and insulated where it runs through cold spaces
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
- A check of your hot water system, and the pressure and flow rate at the bathroom
Decisions to make first
Hard water
In hard water areas, a scale reducer or water softener protects valves, shower heads and glass. Keep an unsoftened tap in the kitchen for drinking.
Pipe routes
Drilling through the middle of joists, rather than notching the tops, keeps the floor strong. Routes are planned with the joist direction in mind.
Copper or plastic
Copper is rigid and suits pipes on show or near the boiler. Plastic is quicker under floors and inside walls, and long runs need fewer joints.
Gravity or pumped waste
Gravity drainage is always the first choice. A shower waste pump or macerator solves a run that cannot fall, but adds noise, a power supply and servicing.
Rules that apply in Scotland
New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.
In Scotland, the Scottish Water Byelaws 2014 cover new water fittings, with the same 6-litre flush limit and backflow rules. Altering drainage may need a building warrant, so check before moving a WC or adding a new connection to the stack.