What does bathroom plumbing work cost in Lanarkshire?
Our guide range in Lanarkshire is £600–£3,800 including VAT. Prices in Lanarkshire run at about 4% below the UK guide, based on Scotland labour rates.
Like-for-like
- Pressure test
Partial re-route
- Basin or shower moved
New layout
- Pumped waste or macerator
Guide prices for Lanarkshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Lanarkshire?
- East Kilbride
- Hamilton
- Cumbernauld
- Coatbridge
- Airdrie
- Motherwell
- Rutherglen
- Cambuslang
- Wishaw
- Bellshill
- Blantyre
- Larkhall
Supplies across most of Lanarkshire are soft. In soft water, taps, wastes and toilet pans scale up slowly, so brushed and matt finishes are a safe choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. Plumbing surveys in East Kilbride include a look at the existing pipework for lead, corrosion or poor support before we quote.
What the job includes
- Draining down and isolating supplies, with the rest of the house back on water as soon as possible
- Basin, bath and shower wastes sized and laid to a steady fall, with traps that hold their water seal
- A pressure test of new pipework before walls are closed in and floors go down
- New hot and cold pipework in copper or plastic, properly clipped, and insulated where it runs through cold spaces
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
- A check of your hot water system, and the pressure and flow rate at the bathroom
Decisions to make first
Concealed or exposed valves
Concealed shower valves look neater but need an access route for servicing. Exposed bar valves are easier to reach and replace.
Pipe routes
Drilling through the middle of joists, rather than notching the tops, keeps the floor strong. Routes are planned with the joist direction in mind.
Hard water
In hard water areas, a scale reducer or water softener protects valves, shower heads and glass. Keep an unsoftened tap in the kitchen for drinking.
Copper or plastic
Copper is rigid and suits pipes on show or near the boiler. Plastic is quicker under floors and inside walls, and long runs need fewer joints.
Rules that apply in Scotland
New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.
In Scotland, the Scottish Water Byelaws 2014 cover new water fittings, with the same 6-litre flush limit and backflow rules. Altering drainage may need a building warrant, so check before moving a WC or adding a new connection to the stack.