What does bathroom plumbing work cost in North Yorkshire?
Our guide range in North Yorkshire is £550–£3,700 including VAT. Prices in North Yorkshire run at about 7% below the UK guide, based on Yorkshire and the Humber labour rates.
Like-for-like
- Pressure test
Partial re-route
- Basin or shower moved
New layout
- Pumped waste or macerator
Guide prices for North Yorkshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in North Yorkshire?
Most of North Yorkshire has moderately hard water. Taps and wastes will need an occasional descale, and chrome or brushed finishes are easier to keep clean than polished brass. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your York water is hard, a scale reducer or softener on the bathroom supplies can protect valves and shower heads.
What the job includes
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
- New hot and cold pipework in copper or plastic, properly clipped, and insulated where it runs through cold spaces
- Draining down and isolating supplies, with the rest of the house back on water as soon as possible
- A check of your hot water system, and the pressure and flow rate at the bathroom
- A pressure test of new pipework before walls are closed in and floors go down
- The WC connected to the soil stack, or a new branch where the WC is moving
Decisions to make first
Pipe routes
Drilling through the middle of joists, rather than notching the tops, keeps the floor strong. Routes are planned with the joist direction in mind.
Copper or plastic
Copper is rigid and suits pipes on show or near the boiler. Plastic is quicker under floors and inside walls, and long runs need fewer joints.
Hard water
In hard water areas, a scale reducer or water softener protects valves, shower heads and glass. Keep an unsoftened tap in the kitchen for drinking.
Gravity or pumped waste
Gravity drainage is always the first choice. A shower waste pump or macerator solves a run that cannot fall, but adds noise, a power supply and servicing.
Rules that apply in England
New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.
In England, the Water Supply (Water Fittings) Regulations 1999 apply. New drainage or a new connection to the soil stack can be building regulations work under Part H, and a macerator or pumped WC is acceptable only where there is also a WC on gravity drainage elsewhere in the home.