Bathroom plumbing in South Yorkshire

What does bathroom plumbing work cost in South Yorkshire?

Our guide range in South Yorkshire is £550–£3,700 including VAT. Prices in South Yorkshire run at about 7% below the UK guide, based on Yorkshire and the Humber labour rates.

Guide prices for South Yorkshire including VAT. Your itemised written quote after the free survey is the price that counts.

Which towns do we cover in South Yorkshire?

• Sheffield
• Rotherham
• Doncaster
• Barnsley
• Bentley
• Chapeltown
• Darton
• Dinnington
• Adwick le Street
• Rawmarsh
• Maltby
• Thorne
• Wath upon Dearne
• Conisbrough
• Hoyland Nether
• Wombwell
• Mexborough

Supplies across most of South Yorkshire are moderately hard. Taps and wastes will need an occasional descale, and chrome or brushed finishes are easier to keep clean than polished brass. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Sheffield home has a gravity system with a loft tank, we check the head of water before recommending a shower or a pump.

What the job includes

• Basin, bath and shower wastes sized and laid to a steady fall, with traps that hold their water seal
• Draining down and isolating supplies, with the rest of the house back on water as soon as possible
• A check of your hot water system, and the pressure and flow rate at the bathroom
• A pressure test of new pipework before walls are closed in and floors go down
• New hot and cold pipework in copper or plastic, properly clipped, and insulated where it runs through cold spaces
• The WC connected to the soil stack, or a new branch where the WC is moving

Decisions to make first

Pipe routes

Drilling through the middle of joists, rather than notching the tops, keeps the floor strong. Routes are planned with the joist direction in mind.

Hard water

In hard water areas, a scale reducer or water softener protects valves, shower heads and glass. Keep an unsoftened tap in the kitchen for drinking.

Concealed or exposed valves

Concealed shower valves look neater but need an access route for servicing. Exposed bar valves are easier to reach and replace.

Gravity or pumped waste

Gravity drainage is always the first choice. A shower waste pump or macerator solves a run that cannot fall, but adds noise, a power supply and servicing.

Rules that apply in England

New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.

In England, the Water Supply (Water Fittings) Regulations 1999 apply. New drainage or a new connection to the soil stack can be building regulations work under Part H, and a macerator or pumped WC is acceptable only where there is also a WC on gravity drainage elsewhere in the home.