What does bathroom plumbing work cost in Perth and Kinross?
Our guide range in Perth and Kinross is £600–£3,800 including VAT. Prices in Perth and Kinross run at about 4% below the UK guide, based on Scotland labour rates.
Like-for-like
- Isolation valves, new tails
Partial re-route
- Waste re-routed
New layout
- WC moved on the soil stack
Guide prices for Perth & Kinross including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Perth and Kinross?
Most of Perth and Kinross is supplied with soft water. In soft water, taps, wastes and toilet pans scale up slowly, so brushed and matt finishes are a safe choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Perth water is hard, a scale reducer or softener on the bathroom supplies can protect valves and shower heads.
What the job includes
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
- Shower pumps on gravity systems, and macerators or pumped wastes where gravity drainage cannot reach
- Basin, bath and shower wastes sized and laid to a steady fall, with traps that hold their water seal
- Draining down and isolating supplies, with the rest of the house back on water as soon as possible
- A pressure test of new pipework before walls are closed in and floors go down
- The WC connected to the soil stack, or a new branch where the WC is moving
Decisions to make first
Concealed or exposed valves
Concealed shower valves look neater but need an access route for servicing. Exposed bar valves are easier to reach and replace.
Pipe routes
Drilling through the middle of joists, rather than notching the tops, keeps the floor strong. Routes are planned with the joist direction in mind.
Hard water
In hard water areas, a scale reducer or water softener protects valves, shower heads and glass. Keep an unsoftened tap in the kitchen for drinking.
Shower supply
Combi boilers and unvented cylinders give mains pressure. A gravity system with a cold tank may need a pump, but a pump must never be connected to the mains.
Rules that apply in Scotland
New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.
In Scotland, the Scottish Water Byelaws 2014 cover new water fittings, with the same 6-litre flush limit and backflow rules. Altering drainage may need a building warrant, so check before moving a WC or adding a new connection to the stack.