What does a loft bathroom cost in the East Riding of Yorkshire?
Our guide range in the East Riding of Yorkshire is £6,000–£12,000 including VAT. Prices in the East Riding of Yorkshire run at about 7% below the UK guide, based on Yorkshire and the Humber labour rates.
Refit
- Shower, basin and WC replaced
Signature
- Pump or macerator where needed
New loft bathroom
- Formed in an existing loft room
Guide prices for East Riding of Yorkshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in the East Riding of Yorkshire?
Water across much of the East Riding of Yorkshire is hard. If your supply in Kingston upon Hull is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Kingston upon Hull loft shower is weak or the waste drains slowly, the fix is often in the pump or the pipe fall rather than the shower itself.
What the job includes
- A drainage route from the loft to the soil stack with enough fall, or a pumped waste or macerator where the rules allow it
- An extractor fan ducted through the roof or a gable wall, with the duct insulated through cold spaces
- A survey of the headroom across the room, with the usable height marked at each fitting position
- Electrics by a qualified electrician, tested and certified, then tiling, testing and handover
- A shower pump on a gravity system, an electric shower, or advice on moving to mains pressure, depending on your system
- Fitted furniture made to the eaves, so the low space behind the slope becomes storage
Decisions to make first
Gravity or pumped waste
Gravity is silent and maintenance-free. A pumped waste or macerator lets fittings sit away from the stack, provided the house has a WC on gravity drainage elsewhere.
Eaves storage
Low cupboards built into the slope behind the WC or basin take clutter out of the room and hide the pipework.
Getting the water pressure
A pumped shower suits a gravity system with a cold tank; an electric shower heats cold mains water at the point of use; a combi or unvented cylinder gives mains pressure throughout.
Where the shower goes
Under the ridge or in a dormer, where the full height is. A walk-in shower with a single panel is usually easier to fit to a roof line than a framed enclosure.
Rules that apply in England
A bathroom inside an existing loft room does not usually need planning permission, but forming one is normally building-regulations work because of the new drainage, extract ventilation and electrics. A macerator or pumped WC is acceptable only where the home also has a WC on gravity drainage. Under the water fittings rules, a shower pump must never be connected directly to the mains supply.
In England, new drainage and a new connection to the soil stack fall under Part H, a new bathroom needs extract of 15 litres per second intermittent or 8 litres per second continuous under Approved Document F, and new circuits are notifiable under Part P. If the work includes an unvented hot-water cylinder, it must be fitted by a G3-qualified installer.