What does a new shower cost in Bedfordshire?
Our guide range in Bedfordshire is £500–£3,700 including VAT. Prices in Bedfordshire run at about 6% above the UK guide, based on East of England labour rates.
Shower swap
- Existing supply and position
New shower over bath
- Tiling the bath surround
New shower with enclosure
- Tray, enclosure and valve
Guide prices for Bedfordshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Bedfordshire?
Water across much of Bedfordshire is very hard. If your supply in Luton is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier. If the shower in your Luton home swings between hot and cold, a thermostatic valve is usually the fix.
What the job includes
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
- Supply and fitting of the shower valve or unit, riser rail, handset or fixed head
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
- A check of your hot-water system, water pressure and flow rate
Decisions to make first
Head and handset
A handset on a riser rail is versatile and easy for rinsing; a fixed overhead head feels generous but needs strong flow behind it.
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Thermostatic mixer
Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.
Rules that apply in England
The water fittings regulations in each nation do not allow a pump to be connected directly to the mains supply; shower pumps are for gravity systems with a cold tank only. The shower must also be protected against water flowing back into the supply. Electrics must meet BS 7671, with 30 mA RCD protection and at least IPX4 fittings in zone 1, or IPX5 where water jets are used.
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.