- Postcode districts
- LU6
- Nearby
- Luton, Leighton Buzzard and Harpenden
- Guide price
- £500–£3,700
- Typical time on site
- half a day to 3 days
- Water
- Very hard across most of Bedfordshire
- Survey
- Free, at your home
What does a new shower cost in Dunstable?
For Dunstable, our guide range for a new shower is £500 to £3,700 including VAT. Prices in East of England run at about 6% above the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Test and handover
New shower over bath
- Thermostatic bar shower and riser
New shower with enclosure
- Pipework and waste
Guide prices for Dunstable including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Dunstable
We work right across Dunstable — LU6 — and in neighbouring Luton and Leighton Buzzard.
In Dunstable, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. If you are replacing a failed electric shower in Dunstable, we check whether the existing cable and circuit suit the new unit. We test pressure and flow at Dunstable surveys before recommending a shower, so you know how it will perform before you buy.
Water across much of Bedfordshire is very hard. If your supply in Dunstable is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Electrical connection by a qualified electrician, tested and certified
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- Supply and fitting of the shower valve or unit, riser rail, handset or fixed head
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
Decisions to make first
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Thermostatic mixer
Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.
