- Postcode districts
- DH8
- Nearby
- Stanley, Whickham and Blaydon-on-Tyne
- Guide price
- £400–£3,200
- Typical time on site
- half a day to 3 days
- Water
- Moderately hard across most of County Durham
- Survey
- Free, at your home
What does a new shower cost in Consett?
Our guide price for a new shower in Consett is £400–£3,200 including VAT. We adjust the national guide for North East England, where prices are typically about 10% below the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Like-for-like mixer or electric shower
New shower over bath
- Bath screen
New shower with enclosure
- Tiling to the enclosure
Guide prices for Consett including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Consett
In Consett we cover DH8; we also cover Stanley, 5.4 miles away, and Whickham.
Homes in and around Consett vary, so we look at the floor, the walls and the water system before we price anything. For Consett homes with a cold tank in the loft, we check the system before fitting anything, because a pump is only allowed on a gravity supply. If you are replacing a failed electric shower in Consett, we check whether the existing cable and circuit suit the new unit.
Most of County Durham has moderately hard water. A quick wipe of the glass and an easy-clean coating are worth having on a new shower in Consett. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
- A check of your hot-water system, water pressure and flow rate
Decisions to make first
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Electric shower
Heats cold mains water as it flows, so it works without stored hot water. Higher kW units give more flow; 8.5 to 10.5 kW models need a dedicated circuit, often 40 to 45 amps.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.

