- Postcode districts
- TN13
- Nearby
- Tonbridge, Swanley and Hartley
- Guide price
- £500–£3,900
- Typical time on site
- half a day to 3 days
- Water
- Very hard across most of Kent
- Survey
- Free, at your home
What does a new shower cost in Sevenoaks?
In Sevenoaks, a new shower typically costs £500–£3,900 including VAT, based on South East England prices. Prices in South East England run at about 12% above the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Like-for-like mixer or electric shower
New shower over bath
- Bath screen
New shower with enclosure
- Tiling to the enclosure
Guide prices for Sevenoaks including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Sevenoaks
In Sevenoaks we cover TN13; we also cover Tonbridge, 6.5 miles away, and Swanley.
In Sevenoaks, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. If you are replacing a failed electric shower in Sevenoaks, we check whether the existing cable and circuit suit the new unit. For Sevenoaks homes with a cold tank in the loft, we check the system before fitting anything, because a pump is only allowed on a gravity supply.
Supplies across most of Kent are very hard. If your supply in Sevenoaks is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Supply and fitting of the shower valve or unit, riser rail, handset or fixed head
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- Electrical connection by a qualified electrician, tested and certified
- A check of your hot-water system, water pressure and flow rate
Decisions to make first
Power shower
A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.
Electric shower
Heats cold mains water as it flows, so it works without stored hot water. Higher kW units give more flow; 8.5 to 10.5 kW models need a dedicated circuit, often 40 to 45 amps.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.
