What does a new shower cost on Merseyside?
Our guide range on Merseyside is £400–£3,300 including VAT. Prices on Merseyside run at about 6% below the UK guide, based on North West England labour rates.
Shower swap
- Existing supply and position
New shower over bath
- Tiling the bath surround
New shower with enclosure
- Tray, enclosure and valve
Guide prices for Merseyside including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover on Merseyside?
- Liverpool
- Birkenhead
- St Helens
- Southport
- Wallasey
- Bootle
- Bebington
- Huyton
- Kirkby
- Prescot
- Heswall
- Maghull
- Newton-le-Willows
- Golborne
- Formby
- Litherland
- Speke
- Garston
- Halewood
- Moreton
- Haydock
- Hunts Cross
- Allerton
Most of Merseyside is supplied with soft water. If that holds for your street in Liverpool, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. If you are replacing a failed electric shower in Liverpool, we check whether the existing cable and circuit suit the new unit.
What the job includes
- Supply and fitting of the shower valve or unit, riser rail, handset or fixed head
- A check of your hot-water system, water pressure and flow rate
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
- A bath screen, tray or enclosure where the shower is new
- Electrical connection by a qualified electrician, tested and certified
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
Decisions to make first
Electric shower
Heats cold mains water as it flows, so it works without stored hot water. Higher kW units give more flow; 8.5 to 10.5 kW models need a dedicated circuit, often 40 to 45 amps.
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Head and handset
A handset on a riser rail is versatile and easy for rinsing; a fixed overhead head feels generous but needs strong flow behind it.
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Rules that apply in England
The water fittings regulations in each nation do not allow a pump to be connected directly to the mains supply; shower pumps are for gravity systems with a cold tank only. The shower must also be protected against water flowing back into the supply. Electrics must meet BS 7671, with 30 mA RCD protection and at least IPX4 fittings in zone 1, or IPX5 where water jets are used.
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.