What does a bathroom strip-out cost in Norfolk?
Our guide range in Norfolk is £650–£1,900 including VAT. Prices in Norfolk run at about 6% above the UK guide, based on East of England labour rates.
Strip-out only
- Pipework capped safely
Strip-out and prep
- Ready for fitting
Back to brick
- Plaster and tiles removed
Guide prices for Norfolk including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Norfolk?
Supplies across most of Norfolk are very hard. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. Strip-outs in Norwich include the waste going away with a licensed carrier, so nothing is left on the drive or the pavement.
What the job includes
- The soil pipe sealed against smells once the WC is off
- Lights, fan, shaver socket and heated rail disconnected and made safe by a qualified electrician where needed
- Waste loaded and taken away by a licensed waste carrier
- Dust sheets and floor protection on the route out through the house
- Isolating the water and capping the supply to each fitting with a proper end, then checking for leaks
- Removal of the bath or shower tray, enclosure, basin, WC, furniture and accessories
Decisions to make first
Salvage
If you want to keep a cast-iron bath, a radiator or a piece of furniture, say so before we start, so it comes out whole rather than in pieces.
Strip-out only or with prep
Strip-out only leaves walls and floors as found. With prep, walls are boarded or patched and the floor checked and overlaid, ready for fitting.
The floor
Old vinyl or tiles on a ply overlay can come up with the ply. Tiles bonded to a screed may need grinding back or overlaying instead.
Timing
Strip out just before the fit rather than weeks ahead, so the house is without a bathroom for as short a time as possible.
Rules that apply in England
Homes built before 2000 can contain asbestos in textured ceiling coatings, old floor tiles, cistern lids and boxing panels, so suspect materials should be tested before strip-out if there is any doubt. Bathroom waste should be taken away by a licensed waste carrier. Disconnecting electrical items should leave every circuit safe and is a job for a qualified electrician, and any work near a boiler or gas pipe is for a Gas Safe registered engineer.
In England, stripping out a bathroom does not need planning permission or building regulations approval in itself. Building regulations come in with what follows, such as new drainage under Part H or new circuits under Part P.

