What does bathroom underfloor heating cost in Cornwall?
Our guide range in Cornwall is £700–£2,600 including VAT.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for Cornwall including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Cornwall?
Supplies across most of Cornwall are soft. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Redruth bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer.
What the job includes
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- A floor sensor set between the heating runs and wired back to the thermostat
- Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
- A check of the floor construction, the room's heat loss and where the thermostat and supply will go
- The electric mat or cable laid to the open floor, kept clear of where the WC, bath and fixed furniture will sit
- Bringing the system up to temperature gradually once the adhesive and grout have cured
Decisions to make first
Thermostat
A simple dial thermostat, a programmable one with set times, or a smart thermostat you can control from your phone.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Insulation board thickness
Thicker boards warm up faster and lose less heat downwards, but raise the floor; the right choice depends on the door threshold and the next room.
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Rules that apply in England
Electric underfloor heating in a bathroom must be on a circuit with 30 mA RCD protection under BS 7671, and the thermostat is positioned to suit the bathroom zones. There is no separate approval for the heating itself, but it should have its own thermostat and timer so it only runs when needed, and the electrical work must meet BS 7671 — in England and Wales it is notifiable as bathroom electrical work. Any work on a gas boiler for a wet system must be done by a Gas Safe registered engineer.
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

