What does bathroom underfloor heating cost in Somerset?
Our guide range in Somerset is £700–£2,600 including VAT.
Electric mat
- Insulation board
Electric, larger room
- Electrician sign-off
Wet system
- Pipes linked to the heating
Guide prices for Somerset including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Somerset?
Water across much of Somerset is hard. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Bath bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer.
What the job includes
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- A floor sensor set between the heating runs and wired back to the thermostat
- Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
- A check of the floor construction, the room's heat loss and where the thermostat and supply will go
- The electric mat or cable laid to the open floor, kept clear of where the WC, bath and fixed furniture will sit
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
Decisions to make first
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Floor heating and towel rail
Underfloor heating warms the room; a towel rail dries towels. Many bathrooms have both, and a dual-fuel rail keeps working in summer when the boiler is off.
Floor finish
Tiles and stone pass heat through well. LVT and vinyl can work, but check the maximum floor temperature the flooring maker allows.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Rules that apply in England
Electric underfloor heating in a bathroom must be on a circuit with 30 mA RCD protection under BS 7671, and the thermostat is positioned to suit the bathroom zones. There is no separate approval for the heating itself, but it should have its own thermostat and timer so it only runs when needed, and the electrical work must meet BS 7671 — in England and Wales it is notifiable as bathroom electrical work. Any work on a gas boiler for a wet system must be done by a Gas Safe registered engineer.
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.