- Postcode districts
- KY6, KY7
- Nearby
- Kirkcaldy, Dunfermline and Queensferry
- Guide price
- £650–£2,400
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Soft across most of Fife
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Glenrothes?
As a guide, budget £650 to £2,400 including VAT for bathroom underfloor heating in Glenrothes; your written quote will pin it down. Prices in Scotland run at about 4% below the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Mat under the tiles
Electric, larger room
- Programmable smart thermostat
Wet system
- Screed or low-profile boards
Guide prices for Glenrothes including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Glenrothes
We cover every part of Glenrothes, including KY6 and KY7, and nearby Kirkcaldy (5.4 miles) and Dunfermline (13.9 miles).
Homes in and around Glenrothes vary, so we look at the floor, the walls and the water system before we price anything. For Glenrothes homes having the bathroom floor replaced, underfloor heating adds one to two days to the fit. We check door thresholds in Glenrothes homes at the survey, because underfloor heating and new tiles raise the floor slightly.
Most of Fife is supplied with soft water. Soft water is kind to grout, so mid-tone and darker grouts stay looking fresh. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Bringing the system up to temperature gradually once the adhesive and grout have cured
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
Decisions to make first
Insulation board thickness
Thicker boards warm up faster and lose less heat downwards, but raise the floor; the right choice depends on the door threshold and the next room.
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Rules that apply in Scotland
Scotland has no Part P. Underfloor heating added during a straight bathroom refit rarely needs a building warrant on its own, but it must be installed, tested and certified to BS 7671 with RCD protection.

