- Postcode districts
- EN6, WD2, WD23
- Nearby
- Barnet, Enfield and Borehamwood
- Guide price
- £750–£2,600
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Very hard across most of Hertfordshire
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Potters Bar?
In Potters Bar, bathroom underfloor heating typically costs £750–£2,600 including VAT, based on East of England prices. We adjust the national guide for East of England, where prices are typically about 6% above the UK average. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Insulation board
Electric, larger room
- Electrician sign-off
Wet system
- Pipes linked to the heating
Guide prices for Potters Bar including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Potters Bar
In Potters Bar we cover EN6, WD2 and WD23; we also cover Barnet, 3.1 miles away, and Enfield.
Potters Bar gets the same process as anywhere else: a free survey at your home and a written, itemised quote. If your Potters Bar bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer. We check door thresholds in Potters Bar homes at the survey, because underfloor heating and new tiles raise the floor slightly.
Water across much of Hertfordshire is very hard. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- Bringing the system up to temperature gradually once the adhesive and grout have cured
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- A floor sensor set between the heating runs and wired back to the thermostat
- Insulation boards over the subfloor, so heat goes up into the tiles rather than down into the joists or screed
Decisions to make first
Floor heating and towel rail
Underfloor heating warms the room; a towel rail dries towels. Many bathrooms have both, and a dual-fuel rail keeps working in summer when the boiler is off.
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.

