- Postcode districts
- CV37
- Nearby
- Warwick, Royal Leamington Spa and Kenilworth
- Guide price
- £700–£2,400
- Typical time on site
- 1–2 working days (added to a fit)
- Water
- Hard across most of Warwickshire
- Survey
- Free, at your home
What does bathroom underfloor heating cost in Stratford-upon-Avon?
For Stratford-upon-Avon, our guide range for bathroom underfloor heating is £700 to £2,400 including VAT. The figure depends on the size of the room, whether anything moves, and the products you pick.
Electric mat
- Thermostat and RCD-protected supply
Electric, larger room
- Whole floor coverage
Wet system
- Manifold or single-zone kit
Guide prices for Stratford-upon-Avon including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Stratford-upon-Avon
We cover every part of Stratford-upon-Avon, including CV37, and nearby Warwick (8.2 miles) and Royal Leamington Spa (10.2 miles).
In Stratford-upon-Avon, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. Where a Stratford-upon-Avon home already has a heat pump, or the heating is being altered, a wet underfloor system is worth comparing with electric. If your Stratford-upon-Avon bathroom has a cold tiled floor and no room for a bigger radiator, an electric mat under new tiles is the simplest answer.
Supplies across most of Warwickshire are hard. Hard water leaves white marks on dark grout and gloss tiles, so matt finishes and stain-resistant grout are the practical choice. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- For wet systems, pipes in low-profile boards or screed connected to a manifold or single-zone kit, with any boiler work done by a Gas Safe registered engineer
- A floor sensor set between the heating runs and wired back to the thermostat
- A dial, programmable or smart thermostat, with the supply RCD protected, tested and certified by a qualified electrician
- Resistance and insulation tests on the mat before, during and after tiling, with the readings recorded
Decisions to make first
Electric or wet
Electric is cheaper to install and quick to lay in one room. Wet costs more upfront but is usually cheaper to run where it is fed by a gas boiler or heat pump.
Mat or loose cable
Mats are quickest on square, open floors. Loose cable is easier to route around awkward shapes, pipe boxing and a curved shower area.
Rules that apply in England
In England, a new circuit for underfloor heating is notifiable under Part P, and so is connecting it to an existing circuit in a room with a bath or shower. The electrician either self-certifies through a competent person scheme or the work is notified to building control.
