What does a new vanity unit cost in Greater Glasgow?
Our guide range in Greater Glasgow is £350–£1,450 including VAT. Prices in Greater Glasgow run at about 4% below the UK guide, based on Scotland labour rates.
Fit your unit
- Sealed and tested
Supply and fit
- Floor-standing or wall-hung unit
Double or bespoke
- Stone or solid-surface top
Guide prices for Greater Glasgow including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Greater Glasgow?
Supplies across most of Greater Glasgow are soft. In soft water, taps, wastes and toilet pans scale up slowly, so brushed and matt finishes are a safe choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Glasgow water is hard, a tap with a removable aerator and a smooth one-piece basin top are easier to keep clean.
What the job includes
- Isolation valves on the hot and cold supplies, so the tap can be changed later without draining the system
- Removal of the old basin and pedestal, or old vanity, and taking it away
- A new tap, trap and the correct slotted or unslotted waste for the basin
- Moving the waste and supply positions where the new unit needs them higher, lower or to one side
- Fitting the unit level, with the basin sealed to the top and the top sealed to the wall
- A check that the wall can carry a wall-hung unit, with fixings to suit solid or stud walls
Decisions to make first
Wall-hung or floor-standing
Wall-hung units leave the floor clear and are easy to clean under, but need a strong wall. Floor-standing units hold more and suit weak or uneven walls.
Width
Compact units around 400 mm wide suit cloakrooms; family bathrooms often take 600 to 800 mm for one basin and 1200 mm or more for two.
Basin type
An inset or semi-recessed basin, a one-piece moulded top, or a countertop basin on a worktop. Countertop basins need a tall tap or a wall-mounted one.
Waste and overflow
A basin with an overflow takes a slotted waste; one without needs an unslotted waste, often a push-button 'click-clack' type.
Rules that apply in Scotland
Replacing a basin with a vanity unit does not need planning permission or building regulations approval. The new tap must meet the water fittings rules, including protection against backflow, and the waste should connect to the existing drainage through a proper trap. If the unit has a light, or a lit mirror goes above it, the electrical work must suit the zone it sits in under BS 7671 and be RCD protected.
In Scotland, a replacement vanity unit does not need a building warrant. The Scottish Water Byelaws 2014 cover the new tap and supplies.