What does a new vanity unit cost in Perth and Kinross?
Our guide range in Perth and Kinross is £350–£1,450 including VAT. Prices in Perth and Kinross run at about 4% below the UK guide, based on Scotland labour rates.
Fit your unit
- Sealed and tested
Supply and fit
- Floor-standing or wall-hung unit
Double or bespoke
- Stone or solid-surface top
Guide prices for Perth & Kinross including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Perth and Kinross?
Most of Perth and Kinross is supplied with soft water. In soft water, taps, wastes and toilet pans scale up slowly, so brushed and matt finishes are a safe choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. We quote vanity unit work in Perth after seeing the wall and pipework, so any re-tiling is on the quote from the start.
What the job includes
- A check that the wall can carry a wall-hung unit, with fixings to suit solid or stud walls
- Isolation valves on the hot and cold supplies, so the tap can be changed later without draining the system
- Moving the waste and supply positions where the new unit needs them higher, lower or to one side
- Testing for leaks and checking the trap holds its seal
- Fitting the unit level, with the basin sealed to the top and the top sealed to the wall
- Patching or re-tiling the wall where the old basin left gaps
Decisions to make first
One basin or two
Two basins help a busy household if the wall is long enough. In a smaller room, one basin with a longer top often works better.
Waste and overflow
A basin with an overflow takes a slotted waste; one without needs an unslotted waste, often a push-button 'click-clack' type.
Wall-hung or floor-standing
Wall-hung units leave the floor clear and are easy to clean under, but need a strong wall. Floor-standing units hold more and suit weak or uneven walls.
Drawers or doors
Drawers keep things visible and reachable but lose some space to the trap. Doors give a deeper cupboard and cost less.
Rules that apply in Scotland
Replacing a basin with a vanity unit does not need planning permission or building regulations approval. The new tap must meet the water fittings rules, including protection against backflow, and the waste should connect to the existing drainage through a proper trap. If the unit has a light, or a lit mirror goes above it, the electrical work must suit the zone it sits in under BS 7671 and be RCD protected.
In Scotland, a replacement vanity unit does not need a building warrant. The Scottish Water Byelaws 2014 cover the new tap and supplies.