What does a walk-in shower cost in Oxfordshire?
Our guide range in Oxfordshire is £2,800–£6,700 including VAT. Prices in Oxfordshire run at about 12% above the UK guide, based on South East England labour rates.
Tray and screen
- Tiling to the shower walls
Frameless upgrade
- Large tray and frameless screen
Tiled level floor
- Level threshold
Guide prices for Oxfordshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Oxfordshire?
Most of Oxfordshire has hard water. If your supply in Oxford is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier. For a walk-in shower in Oxford, we check the water pressure first, so the head you choose will actually perform.
What the job includes
- Silicone, a full-flow test for leaks and spray, and handover
- A low-profile stone-resin tray, or a floor former with a linear drain for a tiled level floor
- Removal of the old bath or enclosure and making good to the walls and floor
- Wall tiling, with an optional recessed niche
- Tanking to the shower walls, and to the floor where it is tiled
- A thermostatic valve with a riser rail, a fixed head or both
Decisions to make first
Tray or tiled floor
A tray is quicker, costs less and has a small lip. A tiled floor with a linear drain sits level with the rest of the room and lets one tile run throughout.
Head
A large overhead head feels luxurious but needs good flow. A handset on a riser is easier for rinsing hair and cleaning the shower.
Tray length
Go long rather than wide. A 1400 to 1700 mm tray with a 900 to 1200 mm panel leaves a dry walkway; a 1200 mm tray works but gives less margin for spray.
Valve
An exposed bar valve with a riser rail is easy to fit and service. A concealed valve hides the pipework and suits a fixed overhead head.
Rules that apply in England
Fitting a walk-in shower does not need planning permission. The light and fan above the shower are in zone 1 up to 2.25 m and must be at least IPX4, or IPX5 where water jets are used, with 30 mA RCD protection on every circuit under BS 7671. Under the water fittings rules, a shower pump may only be used on a gravity system with a cold tank, never on the mains, and the shower needs protection against water flowing back into the supply.
In England, moving or adding lights, a fan or a shower circuit in a room with a bath or shower is notifiable under Part P. A tiled level floor that needs a new drain connection at the soil stack can bring in Part H.