What does a bath to shower conversion cost in Argyll and Bute?
Our guide range in Argyll and Bute is £1,900–£4,800 including VAT. Prices in Argyll and Bute run at about 4% below the UK guide, based on Scotland labour rates. Travel and delivery to islands and remote areas are priced on your quote.
Tray and enclosure
- Bath removed, tray in its place
Walk-in shower
- Concealed valve, rainfall head
Level-access floor
- Grab rails and seat options
Guide prices for Argyll & Bute including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Argyll and Bute?
Most of Argyll and Bute is supplied with soft water. If that holds for your street in Helensburgh, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. If someone in your Helensburgh home is finding the bath side harder to step over, a low or level-access tray removes the problem.
What the job includes
- Removal of the bath, panel and taps, and disposal of the waste
- Silicone, a full-flow test and a tidy finish where the new tiling meets the old
- A survey of the bath space, the waste position, the floor and your water system
- Grab rails and a fold-down seat if you want them
- A low-profile tray, or a former and tanking for a level-access floor
- Boarding, tanking and re-tiling of the shower walls
Decisions to make first
Safety extras
A fold-down seat, grab rails and a slip-resistant tray cost little at the time of fitting and are much harder to add later.
Enclosure or walk-in
An enclosure with a door keeps all the water in and suits a shorter space. A walk-in panel makes the most of the full 1700 mm length an old bath leaves.
Low tray or level floor
A low-profile tray has a small lip. A level-access floor removes the step altogether but needs a former, tanking and a linear drain.
Mixer or electric shower
A thermostatic mixer draws on your hot-water system. An electric shower heats cold mains water as it flows and needs its own circuit.
Rules that apply in Scotland
Converting a bath to a shower does not need planning permission. The shower area is a special location under BS 7671, with 30 mA RCD protection on every circuit and at least IPX4 fittings in zone 1 above the tray up to 2.25 m. A shower pump can only be used on a gravity system with a cold tank, never on the mains. Where the conversion adapts the home for a disabled person, the work can be zero-rated for VAT under HMRC VAT Notice 701/7.
In Scotland, a bath to shower swap in the same position rarely needs a building warrant, but a level-access floor that alters drainage or structure may. For adaptation help, councils run a Scheme of Assistance rather than Disabled Facilities Grants.